Thread: Discussion Molded DLG wing TE
View Single Post
Old Jun 21, 2012, 02:28 AM
chetosmachine is offline
Find More Posts by chetosmachine
chetosmachine's Avatar
Madrid, Spain
Joined Sep 2004
1,112 Posts
I cut my rohacell 5mm shorter chord wise so it stops aprox 5mm away from TE and when I do mu layup, since it's made with disser, I also cut it shorter so I get the thinnest TE. If I have the inner layer with disser up to the TE, it's much thicker with the disser tows placed aprox at the same spots. It also is weaker, since the bumps displace the splooge and the adhesion is not great.

I put the disser on the inner side because this way I get the best adhesion between the rohacell and the skins, without bumps or voids.
chetosmachine is offline Find More Posts by chetosmachine
Reply With Quote