View Single Post
Old Jun 20, 2012, 09:12 PM
simonk is offline
Find More Posts by simonk
hacker
Canada, BC, North Vancouver
Joined Dec 2010
944 Posts
Quote:
Originally Posted by kapteinkuk View Post
The gadgets-freaks will not pitch a tent over this one, It is the same, tired old AVR-chip. (Sorry TC ) However, it runs on a 20MHz crystal, so output resolution and jitter is better than before.
Hi, kapteinkuk! Good to see that it has a 20MHz crystal and an ESC calibration mode! I'd probably want to add CPPM input mode so that we can just buy a simple receiver and only connect the one signal wire. It needs reordering support for some radios, but it's not that difficult otherwise.

Are the lines drawn between the motors not quite perfect in the picture, or is that just bad image scaling?
simonk is offline Find More Posts by simonk
Reply With Quote