View Single Post
Old Jun 19, 2012, 11:10 AM
rrosas is offline
Find More Posts by rrosas
Registered User
Joined Mar 2012
2 Posts
Saving G-Sensor data

I have a 3 Axis G-Force MicroSensor (GFORCE-LOW) connected to a eLogger V4. Both products were purchased less than two months ago and updated with lastest versions.
I can see the G-Force reading using the Eagle Tree Software in Live Mode, and play them back after downloading from the logger.

After saving the recorder file or session to a .CDR, In the recorder file only
Milliseconds IsEvent EventError EventData Altitude Airspeed ServoCurrent*100 Throttle PackVolt*100
Amps*100 Temp1*10 Temp2*10 Temp3*10 RPM GPSLat GPSLon GPSAlt
GPSSpeed GPSCourse GPSDist GPSUTC NumSats GPSFlags SpektrumHolds SpektrumLostFrames SpektrumAFades SpektrumBFades SpektrumLeftFades SpektrumRightFades GPSUTC-ASCII HDOP*10
titles appear, but no G Force readings.

After opening the previously saved recorded CDR file the G-Force paramaters are lost and no data is displayed.

How can I save the G-Force parameters?
Thanks!
rrosas is offline Find More Posts by rrosas
Reply With Quote