View Single Post
Old Jun 16, 2012, 12:45 PM
-= GYRO =- is offline
Find More Posts by -= GYRO =-
Suspended Account
United States, NV, Las Vegas
Joined Nov 2010
3,139 Posts
Quote:
Originally Posted by dfrazier View Post
I would still be cautious of that BEC. When you get the new servos installed you need to load test the bec. Put pressure on the control surfaces and work the sticks or just hold pressure on all control for a few minutes. Watch the voltage output with the telemetry or a known good voltmeter. Its possible your bec is not strong enough and could reset in flight under a load.
I'll keep that in mind, however I tested it with two known functional BECs. They are 3a 5/6v selectable, so I'm sure the cheap servos were just overamping the BEC.
-= GYRO =- is offline Find More Posts by -= GYRO =-