View Single Post
Old Jun 15, 2012, 09:35 PM
-= GYRO =- is offline
Find More Posts by -= GYRO =-
Suspended Account
United States, NV, Las Vegas
Joined Nov 2010
3,139 Posts
Originally Posted by AndyKunz View Post
If the receiver is reset (low power) then it will have 0 because that's all the frames and holds since it's last power-up. The TM1000 does NOT remember anything, it's just a pass-through device for that data.


then what is the point of the screen on the dx8 showing the F and H numbers if it doesn't count them? It seems to count the antenna numbers just fine (when flying on different airplane)

Thanks for reading this thread and weighing in.

-= GYRO =- is offline Find More Posts by -= GYRO =-