Thread: Discussion Multiplex Fun Cub
View Single Post
Old Jun 15, 2012, 08:37 AM
mrc3 is offline
Find More Posts by mrc3
Registered User
United States, MN, Maple Grove
Joined Jun 2011
42 Posts
Quote:
Originally Posted by Starving Bushman View Post
I am trying to, but do not yet, understand the whole electrical "equation" to ensure a good setup. So I am seeking advice for the best prop for this motor. I have a bigger motor that I will put on the Fun Cub later but I was going to start with this one..........

Turnigy D3530/14 1100KV

Spec.
Battery: 2~4 Cell /7.4~14.8V
RPM: 1100kv
Max current: 22A
No load current: 1.6A
Max power: 315W
Internal resistance: 0.077 ohm
Weight: 73g (including connectors)
Diameter of shaft: 5mm
Dimensions: 35x30m
Prop size: 7.4V/12x6 14.8V/8x4
Max thrust: 1100g

I have 3s 2200mah batteries to use with it so maybe a ?????

I have a watt meter to test but I don't want to just go buy 10 props not knowing what I'll use so any guidance would be appreciated.
I would suggest that an APC 11x5.5 be one of the first props you try.

Mike
mrc3 is offline Find More Posts by mrc3
Reply With Quote