Thread: Discussion DIY CNC Router for modelers
View Single Post
Old Jun 13, 2012, 06:36 AM
michaelghammer is offline
Find More Posts by michaelghammer
Registered User
michaelghammer's Avatar
Denmark
Joined Dec 2004
563 Posts
Thanks legout

A lot of DIY CNC Routers use a kind matrix built-up base like this.
If you could find a way to get the parts cut on a CNC, the base would end up very torsion resistant and precise.

Good luck with your CNC and feel free to post your progress in this thread.

- Michael Hammer
michaelghammer is offline Find More Posts by michaelghammer
Reply With Quote