View Single Post
Old Jun 12, 2012, 09:13 AM
FLAME747 is offline
Find More Posts by FLAME747
Static Model Collector LOL
Katy, TX
Joined Dec 2009
1,448 Posts
Ok let's go back to basics

From the limited info that's available, the unit needs to be mounted on a flat surface, from experience when I used my FY 20 even though the unit was placed on a flat surface in the model, once the unit was activated it tend to pitch down, and roll to the right

Solution - 1 either use trim to keep the model level, it worker but took away from the models flight performance

Or 2 shim the unit to achieve level flight without using excessive trim

On the FMA Co-Pilot II, one can compensate for any unwanted roll, and pitch by using flight angles, so that the control surface stays level at neutral

In short, what options are available to trim out any unwanted pitch and roll tendencies with the guardian

Thanks

FCA

Aero, Al. Keep up the good work
FLAME747 is offline Find More Posts by FLAME747
Reply With Quote