View Single Post
Old Jun 12, 2012, 04:38 AM
yurstruly is offline
Find More Posts by yurstruly
Registered User
Chicago, USA and Manila, Philippines
Joined May 2007
180 Posts
thanks for your help guys.. atleast i have a better idea how to disassemble it.. i will definitely inspect the gear if there's any burr stuck in between .. i'm just a little disappointed for having a DOA rudder servos from a brand new Beast and at the same time having it on back order also.. this is the first time had this bad experience after so many purchases of different aircraft from them this past few years.. but still a great customer service from them as usual..


Quote:
Originally Posted by WSEN View Post
You don't need to take the wings/etc off to replace the brick. Like they said, remove the control rods from the rudder and elevator. Then carefully slice through the silicone-like caulk holding the brick in place and gently pry it loose. Just finished replacing mine.


Quote:
Originally Posted by RCBABBEL View Post
yurs,

Maybe this ole V1 post with pics will be of some help...
http://www.rcgroups.com/forums/showp...&postcount=336

rc
Quote:
Originally Posted by NitroCharged View Post
yurstruly, I would recommend cleaning the bur off the rudder gear first to see if it clears the problem before removing the board. Use a new exacto blade for the job. It's just a tiny extra bit of plastic between the teeth that needs to be picked off.
yurstruly is offline Find More Posts by yurstruly
Reply With Quote