View Single Post
Old Jun 11, 2012, 06:40 AM
leadfeather is online now
Find More Posts by leadfeather
Winging it >
leadfeather's Avatar
Joined May 2006
10,246 Posts
Quote:
Originally Posted by Truglodite View Post
I checked DCalc SPC and it says roughly 70% efficiency; not bad for 9T-23awg running 200W, but I was hoping for more. I'm curious to see how it would run with a single mag 8p rotor. I'm sure it wasn't all that fun getting 16mags back in; I've never glued 16 mags in a 'wonder motor now that I think about it.

Kev
Gluing the magnets in wasn't really hard. No spaces, just push the magnet in place next to the last one. I glued them in place two at a time. Putting in a NS combination would hold the magnets in place. When putting in a single N next to a N, I would have to hold the magnet in place until the glue set up otherwise the repelling force would create a gap.

Testing the single magnet 8p is a good idea for comparison.

I was a little surprised that the kV wasn't higher on this first try.

Kev and others, what is the best ( not too hard) BW motor you have done so far for speed?
leadfeather is online now Find More Posts by leadfeather
Reply With Quote