Thread: Discussion X250 MWC Quadcopter
View Single Post
Old Jun 10, 2012, 06:16 PM
tech69x is offline
Find More Posts by tech69x
Custom quad builder
tech69x's Avatar
United States, TX, Spring
Joined Apr 2012
2,364 Posts
Quote:
Originally Posted by Chevycruizer View Post
Did it change from version 1.9?

Take your props off, just to be safe...

Arming - Learn to recognise that your WiiCopter is ARMED. Hold right Yaw (or right cyclic) for 1 sec (with throttle down)- you will see the Green LED come on - stays on SOLID
If LED does not come on GREEN - then increase YAW travel on the Tx (see Transmitter Calibration procedure - above top) - or Check the THRO is not actually reversed by mistake (Futaba) - then trim down a few clicks on the THRO trim. If it still won't arm connect FTDI and use the JAVA-Config (see below - install JAVA) to make sure the Throttle PWM is below 1100 (normal THRO range is 1100-1900) - In order to arm - the Wii CPU is looking for THRO and is a valuable guide to trouble-shoot a CPU which won't apparently arm.

MulitWiiCopter Wiki
Yes I changed from 1.9 to 2.0 I have done all of the above
tech69x is offline Find More Posts by tech69x
Reply With Quote