View Single Post
Old Jun 08, 2012, 04:29 PM
rubenhak is offline
Find More Posts by rubenhak
Registered User
Joined May 2009
77 Posts
Discussion
Turnigy Talon Quadcopter V2 Build

Hi Everybody,

This is my first multi rotor build. Just want to share items I purchased and to get a feedback in chase I need to get some extra or use a different parts until the package arrives from HK. Here they are:

With those electronics which of the props would you guys suggest to use on the quad? I'm planning to build it in X configuration. 10x6 or 11x4.7? Also as much as I'm aware the stock controller board comes with "+" configuration firmware, right? Which firmware(and version) would you recommend for me to use?

Also, when resoldering ESC wires would you recommend using 16, 18 or maybe different gauge wires ? The stock wires would definitely not be long enough since I'd prefer to route the wires through the carbon fiber tube of the frame.

Any feedback is appreciated!

Thank you,
Ruben
rubenhak is offline Find More Posts by rubenhak
Reply With Quote