View Single Post
Old Jun 05, 2012, 07:47 AM
saucisse is offline
Find More Posts by saucisse
Don't disturb the pilot !!!
saucisse's Avatar
Canada, QC, Quebec
Joined Jun 2008
2,190 Posts
Well because the stick inputs are not on the same side...

For the rc transmitter/radio calibration, you need to do this only the first time use are using your radio/new rx with the aq board.

Remove all props, power the radio then power the aq board.
Throttle completely down, all other sticks centered...in other words, lower the throttle and do not touch anything else. Be sure all the trims are also centered. Then press and hold the button on the aq board until the blue LED comes back.

For sensor calibration ( I'm doing this to every to every pack), power the radio, then power the aq board, give full throttle and full rudder left, hold until the blue LED comes back on. Throttle down and let go the rudder input.

That is it

Quote:
Originally Posted by nebstress View Post
Mode 2,

Why, what difference does that make?
saucisse is offline Find More Posts by saucisse
Reply With Quote