Thread: Careful! 3D is NOT for everyone
View Single Post
Old Jun 04, 2012, 11:10 AM
CaptJac is offline
Find More Posts by CaptJac
Rotor Controller
CaptJac's Avatar
Aachen Germany
Joined Dec 2007
2,394 Posts
Quote:
Originally Posted by steveap1 View Post
I want to try these settings on my mcpx as well, but I don't have a pitch gauge. Is there one that works well for the mcpx?
You can eyeball the blades on an mCPx (almost as close as a pitch gauge) by "sighting" down the blade from the ends. The blade tips are nearly flat - so 0 is pretty easy to determine - then "reverse-engineer" the rest of the settings by adding (or subtracting) 20% to the percentage number on your pitch curve. Example if 0 is 44% ... try 52% for 2 ... 60% for 4 ... 68% for 6 ... 36% for -2 Should be close enough for government purposes but tweak the numbers for best results
CaptJac is offline Find More Posts by CaptJac
RCG Plus Member