Originally Posted by Jeandredubois
How do you guys extend the motor wires? do you just solder longer wires on or what?
I know the space where the wires goes inside the plane is not very big!
And what wire do you use - 18,16awg?
Mine were barely long enough to solder bullet connectors to. I taped the wires sideways out of the fuse and soldered the bullet connectors to them. Did it one by one and taped up that area of the fuse with blue masking tape to protect it. Are yours shorter than this? You may have to remove the motor assembly to add wires on to lengthen it, but I don't know how you are going to get them routed again, although it was done at the factory somehow. That's the thing about these cheap chinese brands, there are often things that don't work and have to be modified, and we don't even have adequate instructions, if we have them at all.