Thread: Discussion MJX-F45 Single Rotor FP
View Single Post
Old May 31, 2012, 11:35 AM
BThirsk is offline
Find More Posts by BThirsk
Brent 黑雁
BThirsk's Avatar
Canada, AB, Ponoka
Joined Jan 2012
1,801 Posts
Quote:
Originally Posted by Moki155 View Post
then will soon die the tail motor. the twitching is if the carbon brushes are at the end. itīs the same as me. today i tested the Xtreme Direct Drive Tail from Honey Bee FP. but itīs not better as the original. now i will go to brushless. i mod a old Turnigy 6A ESC like this http://home.versanet.de/~b-konze/blc_6a/blc_6a.htm
It saves the pwm to ppm converter and now i wait for the motor. next try
Seeing you are an electrical wizard, when your brushless motor is running what kind of voltage do you get to the tail motor. I’m not sure if this would be an issue, but if the system voltage was getting low could there be an amperage increase causing problems with the tail motor. I have no idea what the correlation is in a variable speed brush motor between Volt/Amp.
BThirsk is offline Find More Posts by BThirsk
Reply With Quote