View Single Post
Old May 26, 2012, 02:36 AM
freshmint is offline
Find More Posts by freshmint
Registered User
Joined Nov 2011
399 Posts
Quote:
Originally Posted by garris2 View Post
Usually an ESC has a BEC built into in which case you either don't need the UBEC that you have connected to the Receiver battery input, or you need to disconnect the red wire coming out of your ESC.

If you go with disconnecting the ESC red wire and use the UBEC, you should connect the UBEC input to the ESC side of the eLogger such that the eLogger will also record your UBEC's current.

You should also consider removing the ground wire connected to the UBEC as this completes a ground loop path created in conjunction with the ground wire in the Throttle Out - ESC path.

Yes, your Camera and Mic are getting power from your second battery through the OSD Pro. This is called 'Pass-Through'.

You can remove the second battery and power all from your main pack but be sure to make the changes above to remove the ground loop.

Geoff
If I'm using the CC bec 10A do I still remove the ground wire on the ubec?
freshmint is offline Find More Posts by freshmint
Reply With Quote