Thread: Discussion Spektrum Telemetry Options
View Single Post
Old May 21, 2012, 07:45 PM
scoris is offline
Find More Posts by scoris
Registered User
Canada, ON, Burlington
Joined May 2012
6 Posts
I am now installing the air speed indicator on my hangar P51 mustang sport (with Spektrum DX7s). I m going to drill a whole in the wing's leading edge and insert the Pitot tube. Can anyone advise me on how should I glue it to the wing? Epoxy or silicon?

I noticed some have used Robart Quick Disconnect to facilitate connecting/disconnecting of air tubing when putting the wings on or off. I have another idea - i wonder if I can make it work: install the sensor in the wing, very close to the tube (so then I'll have the air line very short) and run an X_BUS extension through the wing to the TM1000 in the fuselage. This way all I'll have to connect/disconnect will be an electrical cable. Problem is that I can't find a proper male/female XBUS extension cable. Any thoughts?
scoris is offline Find More Posts by scoris
Reply With Quote