View Single Post
Old May 15, 2012, 07:21 PM
thwaitm is offline
Find More Posts by thwaitm
Team WarpSquad
United Kingdom, England, Royal Leamington Spa
Joined Jun 2011
3,001 Posts
I'm not the crazy one. You are not reading what I've written.

My problem has nothing at all to do with the ESC, trims etc.

My FF board won't arm because the TX-FlightController combo hasn't been calibrated. Simple as that.
If you would actually read the FF FC doc you can see in black and white that it says the board will not arm if calibration hasn't been completed.

My only mistake was thinking that the RX had not bound to the TX when in fact it had.

I'm sure you are right for the problem you are talking about but it's just a different problem to the one I have and in fact I totally agree with you that some ESCs won't arm if the throttle is at minimum. Only last night I was flashing some ESCs and during testing had an ESC fail to arm because I'd disconnected and reconnected the ESC-Battery connection (and therefore the RX power) without the stick being at full 0 position.
thwaitm is offline Find More Posts by thwaitm
Last edited by thwaitm; May 16, 2012 at 04:48 AM.
Reply With Quote