Thread: Discussion BUSA N17 1/6 Build
View Single Post
Old May 13, 2012, 09:35 AM
Thermalin is offline
Find More Posts by Thermalin
I'm a pilot... 100 yrs to late
Thermalin's Avatar
USA, FL, Palm Harbor
Joined Jan 2005
3,831 Posts
Rudder and elevator servos are in and working moving the surfaces as expected. I needed to put one upright and invert one due to the bellcrank connects being on different planes. Bending the wiire for the rudder control when the servo was upugright required a to severe bend and caused binding issues.

THe wires for the elevators are not parallel but it doesn't seem to cause issues as the length of the brank and horns are the same distance at the pull pll connections. They aren't parallel as i was matching the actual setup in the real thing. They near each other at the fuse entry point and then expand apart agin in my setup . Maybe on the real thing they were parallel to the control arm in the fuse.
Thermalin is offline Find More Posts by Thermalin
Last edited by Thermalin; May 13, 2012 at 09:52 AM.
Reply With Quote