Originally Posted by ALEX HEWSON
SO If i want to do some computer design work for airframes, to then finally convert to an ISO program for a CNC mill to read, where do I start?
I have CNCs at work, I may as well use them!!!!
What you after Alex
I can do CAD!
pending time frame, maybe we can collaborate.
you will need some one to do the cutter paths, post process into iso.
If you wanted to do it your self, have a look in the CAD section. http://www.rcgroups.com/cad-cam-660/
Loads of support on programs / how to's and every thing you need to get going.
Consider what you use at work too, as this could open doors.