View Single Post
Old May 07, 2012, 12:12 PM
PittSpecial is offline
Find More Posts by PittSpecial
Right Rudder
PittSpecial's Avatar
USA, FL, Orlando
Joined Nov 2010
10,554 Posts
Quote:
Originally Posted by Reef_rc View Post
My RimFire .10 burnt out recently. Not sure what happened. There seems to be burnt residue inside the motor. Seems like inside wire melted due to short or something. I have 3 RimeFire .10 motors and this is the first to go under for whatever reasons.

The EF 40 amp ESC Pro is good. I have since installed another motor back on and ready to take this baby back in the air.
Again, the stock setup and with the recommended propeller assuming 3-cell Li-POLYs will draw (Current) around the high 20's and closer to 30-AMPs. That is a lot of current for the wire strand size they used on this motor.

Have you checked the temperature of the motor during a typical run?

Too much heat will melt the glue holding the magnets and / or holding the wire windings and will cause issues!

PittSpecial is offline Find More Posts by PittSpecial
RCG Plus Member