Thread: Discussion Walkera V450D01
View Single Post
Old May 04, 2012, 09:46 AM
jhebbel is offline
Find More Posts by jhebbel
"Watch this!.... Oh crap"
jhebbel's Avatar
United States, FL, Seminole
Joined Jan 2012
1,157 Posts
man im a dope, decided to go back to square one and to a hardware, rx, and tx setup to work some of my kinks out and i found all the problems right off the bat

1) if you look at my photos my FS control rods arnt verticle lol, my swash was not in sync with my blades, dohhhhh!!!

2) my tail blade hub somehow worked its way inboard on the shaft thus limiting my positive travel, dohhhhh!!!

2 minutes and a lil locktite to prevent future slippage and im good to go, sometimes all these new fancy gyros and receivers make you forget the basics that are staring you right in the face...
jhebbel is offline Find More Posts by jhebbel
Reply With Quote