View Single Post
Old May 03, 2012, 09:44 PM
splinterz25 is offline
Find More Posts by splinterz25
Jack of all master of none
splinterz25's Avatar
Baltimore MD USA
Joined Jan 2011
4,830 Posts
Alright ...joneswag looks like you have made a good start make sure your parts are right on the print so it will match the second half ..mine were off a bit so I had to make adjustments but this type of building can be tricky. With the FUSE you will do the same thing...BUT if I had to do it over I would build the second half directly on the first checking every thing w/ a straight edge and a square.

Bruce
splinterz25 is offline Find More Posts by splinterz25
Last edited by splinterz25; May 03, 2012 at 10:31 PM.
Reply With Quote