View Single Post
Old May 03, 2012, 07:04 AM
bgriggs is offline
Find More Posts by bgriggs
Make something. Anything!
bgriggs's Avatar
Syracuse Hancock, New York, United States
Joined Jul 2003
1,024 Posts
Quote:
Originally Posted by obsydian View Post
I'm planning to built a 20x20 CNC router table and I'm leaning towards using the HobbyCNC pro driver. I wanted to know how well the one you built was working and if there's anything you would change?

And thanks for the all the info you've already provided.

-Andy
I am still using the same controller I built at the beginning of this thread. It has been rock solid. If I changed anything it would be to use solid state limit switches instead of micro switches. Hall affect sensors are cheap and work well.

Bill
bgriggs is offline Find More Posts by bgriggs
Reply With Quote