View Single Post
Old Apr 30, 2012, 08:23 PM
djjd42 is offline
Find More Posts by djjd42
Registered User
Joined Jan 2012
16 Posts
Quote:
Originally Posted by LevTor View Post
I need to change the boom. How do guys you do it? I was thinking of the following.
- remove the heat shrink and unsolder the wires so I can slide off the boom.
- replace the boom (does the wire easily slides back to the boom?)
- solder back the wires and heat shrink it.

Is this how you guys do it?
Pretty much, but on mine I opted to wind the wiring around the boom instead of running it back through it. That way I can avoid a bunch of soldering work every time I replace a boom. Folks using solid booms do the same.
djjd42 is offline Find More Posts by djjd42
Reply With Quote