View Single Post
Old Apr 29, 2012, 04:28 PM
darec is offline
Find More Posts by darec
Registered User
Polska, dolnośląskie, Wrocław
Joined Aug 2008
12 Posts
No, we did not try to connect it like the original one...relatively long time ago i found some info that there are advantages of going direct way so i think it is not a good idea to go backwards or i missed something?

Can you explain what these two cuts are for? How did you find out what to do with this clone to make it standalone ITG3205? Do you have a schematic of this clone? or you did a good analayses with magnifing glass vs generic scheme?

Would you indicate how to cut the board to make it as small as possible provided we don't need onboard 3 V regulator but still want to keep pullup resistors on the board after modification...or even without pullups?

now i have just noticed in your picture that 2k pullups are connected to 3v voltage line...in some specific configurations it may not work properly
darec is offline Find More Posts by darec
Reply With Quote