: Build Log
Piper PA8 skycycle
View Single Post
Apr 28, 2012
, 10:22 PM
Kaiapoi , New Zealand
Joined Jun 2007
Tail wheel all sorted....doing a pull-pull cable for the rudder and tail wheel
The servo will drive the tail wheel with two very fine stainless cables and the rod goes up through a nylon bearing into the rudder.
Wings all spackelled and just need a light sand
The next job is to news print cover both wings.
View all Images in thread
all spackelled and light sand then paper covered.
rudder/tail wheel drive.