Thread: New Product Swist
View Single Post
Old Apr 26, 2012, 06:39 AM
VooDoo Child is offline
Find More Posts by VooDoo Child
Drinks Day Old Expired Milk
VooDoo Child's Avatar
United States, OR, Portland
Joined Aug 2010
2,834 Posts
Quote:
Originally Posted by vespa View Post
I've never seen a pylon plane eat an elevator servo but if it somehow did (and somehow survived) you could hammer a strip of sharpened metal in there to chisel that tray out in 5 minutes. I say glue it on in. Rod is a good choice, just check that the servo will stall without buckling the rod. Ideally the rod would be extremely light and thin walled with the largest possible diameter but the typical thick wall stuff is fine also. Check the heli section of your hobby shop for tail rotor pushrods if needed. Also your servo may not end up parallel to the rod so you might need a ball link at that end.
That is a great idea about the heli dept,I drove to three hobby stores before I found one that had a snug fit on the 2-56 all thread....well,back to the hobby store. ; ) and yes,it will need a ball link on the back to keep things smooth.....thanks for the help. Doug
VooDoo Child is offline Find More Posts by VooDoo Child
Last edited by VooDoo Child; Apr 26, 2012 at 05:07 PM.
Reply With Quote