Thread: New Product Swist
View Single Post
Old Apr 26, 2012, 02:23 AM
vespa is offline
Find More Posts by vespa
Freelance selfie photographer
vespa's Avatar
Thousand Oaks, CA
Joined Mar 2004
2,761 Posts
I've never seen a pylon plane eat an elevator servo but if it somehow did (and somehow survived) you could hammer a strip of sharpened metal in there to chisel that tray out in 5 minutes. I say glue it on in. Rod is a good choice, just check that the servo will stall without buckling the rod. Ideally the rod would be extremely light and thin walled with the largest possible diameter but the typical thick wall stuff is fine also. Check the heli section of your hobby shop for tail rotor pushrods if needed. Also your servo may not end up parallel to the rod so you might need a ball link at that end.
vespa is offline Find More Posts by vespa
Reply With Quote