View Single Post
Old Apr 25, 2012, 03:48 PM
headlessagain is offline
Find More Posts by headlessagain
Reap the wild wind
headlessagain's Avatar
Bristol,UK
Joined Feb 2007
5,291 Posts
No problem. The FC 28-12 Brushless Outrunner 1534kv does comes with a mount that is held on with grub screws. If you mount with screws you will have to remove the motor and then re-install. You could use nuts and bolts through the firewall but this might be a bit of an overkill for the motor. It's worth replacing the grub screws with short cross head screws. This is the prop saver http://www.hobbyking.com/hobbyking/s...idProduct=3738 but I'd replace the O rings with surgical tube cut up into rings. Here is a post regarding it's use and possible suppliers
http://www.rcgroups.com/forums/showthread.php?t=1206595
Andy
headlessagain is offline Find More Posts by headlessagain
Reply With Quote