Thread: Discussion What is CG for ST-Models ASW28
View Single Post
Old Apr 25, 2012, 08:20 AM
Riodiler1 is offline
Find More Posts by Riodiler1
Registered User
United States, CA, Livermore
Joined Jan 2005
129 Posts
Discussion
What is CG for ST-Models ASW28

I posted this on the electric aircraft foam forum but didn't get any response so maybe I'll have a little better luck over here.

My ST-Models ASW28 instruction manual is very unclear about the recommended CG. I'm not sure if they goofed during printing but it shows 5mm +/-3mm from a line in the center portion of the wing rather than from the leading edge.

Does anyone know the recommended CG for this plane from the leading edge?

Thanks!
Riodiler1 is offline Find More Posts by Riodiler1
Reply With Quote