Originally Posted by choochoo22
Melnic; These videos are a great explanation of how these work and how to set up different functionality. The two servos as position indicators are a perfect illustration. Thank you.
At the end of part 2 there is a reference to part 3 which is not present. What is in part 3 and where can it be found?
Using the techniques in the videos, I used a combination of travel and sub-trim to set up a 3 position off/low-rate/high-rate which could be useful to some people. Is that perhaps in part 3?
I found part 3, just some other info if your bored and want to listen to me talk more. I should take the highlights then bullet them onto the page that has part 1 & part 2. I will add this vid the Tx setup page.