Thread: Discussion 3DHS 47" Osiris
View Single Post
Old Apr 24, 2012, 03:41 PM
Neil Morse is offline
Find More Posts by Neil Morse
Registered Snoozer
Neil Morse's Avatar
San Francisco, CA, USA
Joined Jul 1999
6,159 Posts
Make two discs out of sandpaper, and mount them back-to-back between the prop adaptor and the spinner back and/or between the prop and spinner back (depending on what's slipping). That usually does the trick. Then you have to carefully hold the prop in the right position as you slowly tighten the prop nut. It also helps to mark the right spot for the position of the prop blade so you can easily see whether it's in the right position as you tighten the nut.
Neil Morse is offline Find More Posts by Neil Morse
Reply With Quote