View Single Post
Old Apr 22, 2012, 11:23 AM
Art_P is offline
Find More Posts by Art_P
Registered User
United States, FL, Daytona Beach
Joined Feb 2012
24 Posts
Originally Posted by Henryms View Post
The Heli starts spinning the minute i click the gear switch on, i can not control that speed at all. I am not touching the elevator switch at all. The switch I was playing with is the rudder, took me a while to figure that the rudder switch is not causing any movement in the tail gear.

Yes it does
I need a tester then... And yes the swashplate does move
Okay, now I understand. I forgot about the upper left switch being labeled "gear". Is the upper right switch in the up position and the left stick in the full down position (as they should be)? It appears that you may be in the 3D mode (right switch down).

The servo may be the problem. You don't need a tester. Just reconnect it to one of the cyclic channels. Disconnect from the connector above and behind the gyro and reconnect to channels 1 or 2. Then see if the cyclic control stick movement moves the servo arm. Pay attention to wire colors and assure that all plugs are oriented correctly.
Art_P is offline Find More Posts by Art_P
Reply With Quote