View Single Post
Old Apr 20, 2012, 09:52 AM
Rayne is offline
Find More Posts by Rayne
"Landing" in a tree somewhere
Rochester, NY
Joined Sep 2009
946 Posts
Did you remember to take out the bind plug, unplug the battery, turn off the radio, turn the radio back on then plug in the battery?

Did the LED's on your transmitter flash indicating it was in bind mode (assuming you had a DX4e)?

Did the receiver's LED blink very rapidly during the bind process then slow?

Was the radio at least a couple feet away from the receiver (having it too close can sometimes cause problems)?

Was the lipo battery fully charged up and are the radio's batteries not dead?

Short of that I'd go back and carefully read through the instructions again to make sure you're not missing something.
Rayne is offline Find More Posts by Rayne
Reply With Quote