Thread: Discussion Pitts Python from foam to balsa
View Single Post
Old Apr 18, 2012, 02:54 PM
Dennis C is offline
Find More Posts by Dennis C
Registered User
Dennis C's Avatar
Grass Valley California
Joined Jun 2004
2,472 Posts
When you get ready to sheet the rear of the fuslage soak the balsa in amonia and water. I wiped amonia on the balsa and ran it under the hot water tap.

Tape it in place and then let it dry before you glue it. pull it around the bend slowly, it is a very tight bend but it will go with out cracks

Dennis
Dennis C is offline Find More Posts by Dennis C
Reply With Quote