View Single Post
Old Apr 18, 2012, 12:36 PM
LanceMc is offline
Find More Posts by LanceMc
Certified Wingnut
LanceMc's Avatar
Delta BC
Joined Jul 2008
381 Posts
Quote:
Originally Posted by JLT_GTI View Post
Another 2 quick questions..

How are you guys placing the outer servos?
Because as you know theese servos have the arm in one side of them



And i realiced that if i put the servo so the arm side its near the horn .. the suplied pushrod its too long and i have to screw the quick link full to get it centered.. but if i turn arround the servo and put the arm end at the oposite side i get more room.. i want to make sure before screwing up

Also.. how are you gluing the servos? i did it allready in a CloudsFly (foamie) and a SIG Ninja (not foamie but foam core wings) but here the servo sits well but seems to have lots of play.. im not sure if double side tape will hold it specially with the torsion needed to fully raise those ailerons
I replaced all the stock servos with those HXT 900s after a stock servo failed on a pre-maiden check. I wrapped the servos in masking tape then used a drop of 5 min epoxy to hold them in place. I remember I had an issue with the servo/horn direction as well, but can't remember how I solved it. I'll check when I get home.
Lance
LanceMc is offline Find More Posts by LanceMc
Reply With Quote