View Single Post
Old Apr 18, 2012, 10:10 AM
SidewaysLS4 is offline
Find More Posts by SidewaysLS4
Redjestird Youser
SidewaysLS4's Avatar
Joined Jan 2009
3,881 Posts
The 1:1 Jetranger has a fairly high main rotor height, so I tried to get it as high as possible using the Gaui shaft. Note that to do this, you need to find a way to get the autorotation gear to accept a 8mm wide main shaft with no step like the Align main shaft. This is done by digging up from somewhere an origional HK500 autorotation bearing hub that is out of spec with the Align design but allows a non-stepped 8mm main shaft to be used. (thanks Cap for that part! )
SidewaysLS4 is offline Find More Posts by SidewaysLS4
Reply With Quote