View Single Post
Old Apr 13, 2012, 12:20 PM
BMatthews is offline
Find More Posts by BMatthews
B for Bruce
BMatthews's Avatar
The 'Wack, BC, Canada
Joined Oct 2002
12,815 Posts
Rogue Titan, consider the size of the table. The one on that HF saw is far, far too small to give you the support to get proper cuts. Even for model work I'd want the table to be a minimum of one foot front to back and about two feet in total width to be able to run aircraft plywood through it. And two feet square with the blade just a little behind mid point would be ideal without being too big and bulky.
BMatthews is offline Find More Posts by BMatthews
Reply With Quote