View Single Post
Old Apr 09, 2012, 08:14 AM
Zr_Flyer is offline
Find More Posts by Zr_Flyer
SoCal
Zr_Flyer's Avatar
Joined Oct 2011
693 Posts
Hi,

I ran into the same problem. I was able to get my esc into programming mode by adjusting the throttle end point above 100% on my TX but then I was not able to get any further because it would not send a 0% signal to the esc. I figure if I really want to program my esc I will need a programming card or will plug it into one of my 6 channel Rx's. The way it is the default values on the esc are working for me, most default to normal start, no brake etc. which is what we want, I just wanted to play with the timing on mine.

I need to update on my progress soon, I have mine flying pretty well. I finally got an 8 tooth pinion that works pretty good.
Zr_Flyer is offline Find More Posts by Zr_Flyer
Reply With Quote