Thread: Discussion Sky Surfer aka Bixler FPV
View Single Post
Old Apr 08, 2012, 06:56 PM
NorCalMatCat is offline
Find More Posts by NorCalMatCat
FPV Electronics For Life!
NorCalMatCat's Avatar
United States, CA, Arcata
Joined Oct 2011
2,668 Posts
Quote:
Originally Posted by WiseDuck View Post
I'm sure my motor is fine, but the prop adapter at the end of the long shaft isn't mounted straight. You can see it move from side to side if you spin it around and if you spin up the motor the whole plane vibrates. It's pretty bad. And because they use some stupid 2.5mm shaft I have to ditch the whole thing since I only have 2 and 3mm collet adapters. So I have to settle for a 1240kv motor until I can replace it with something better.

I'll try hot water tomorrow and see if that works.
Ahh yeah, that will mess it up :P I think a 6x4 is too small for 1450kv...
NorCalMatCat is offline Find More Posts by NorCalMatCat
RCG Plus Member