Thread: Discussion H-bridge motor controller
View Single Post
Old Apr 05, 2012, 03:01 PM
jeffs555 is offline
Find More Posts by jeffs555
"Simplify, then add lightness"
Raleigh,NC
Joined Nov 2000
2,701 Posts
Unless the common mode voltage is a lot higher than the differential voltage, the two probe add invert method works essentially the same as a differential probe.

The only reason I asked about differential is that connecting the probe ground clip to points other than ground can affect the circuit. Not usually a problem if the circuit is low frequency, battery powered and totally isolated from ground and you only need to measure one signal at a time. That seems to be the case here, but since I didn't know exacty where how you were measuring, had to ask. Always have to be careful that the measuring equipment is not changing the operation of the circuit.
jeffs555 is offline Find More Posts by jeffs555
Reply With Quote