View Single Post
Old Apr 05, 2012, 09:01 AM
branded7K is offline
Find More Posts by branded7K
Wyatt Earp
USA, AZ, Kingman
Joined Jun 2008
24 Posts
Newbie to Autogyros

I've always been fascinated with autogyros but have never had any success flying one. This design has piqued my interest once again and the build is underway! I have read this thread several times and only have one question. I only have 6mm EPP at hand for constructing the hub and rotor blades. I do have 2mm carbon fiber rod ordered and on the way for use as leading edge material. I do realize the thicker material will need to be shaved down to maintain the angle for the rotor shims. Should I just wait and order some 3mm stock before proceeding any further on the build?
branded7K is offline Find More Posts by branded7K
Reply With Quote