Thread: Discussion MJX-F45 Single Rotor FP
View Single Post
Old Apr 02, 2012, 05:42 AM
Whizgig is offline
Find More Posts by Whizgig
Whizgig's Avatar
Australia, VIC, Delacombe
Joined Oct 2006
918 Posts
Originally Posted by BThirsk View Post
I used .006" to shim the rotor blades for more tension. I made out of .002 brass shim stock. The center hole is .250" with OD of .650.
Tighten until you have enough tension that the rotor blades will turn the motor.
This heli needs a little more tension than the 9116 double horse due to more flexible blades.
The cyclic response has improved enough to actually do diagonal movements in hover mode under control and it appears to improve hover to now hands off out side without wind.
Thanks for the info It dose make it alot better and even more responsive.
Whizgig is offline Find More Posts by Whizgig
Reply With Quote