View Single Post
Old Apr 01, 2012, 10:19 PM
vtdiy is offline
Find More Posts by vtdiy
low tech high tech
vtdiy's Avatar
Southern Vermont
Joined Feb 2007
3,029 Posts
Quote:
Originally Posted by gmwahl View Post

So just to make sure we are on the same page, once I get my wire heated to the optimum temp for what I'm cutting, and I'm assuming make a cut or two just to be sure that I'm at the best setting that I can be at, then take the measurements. Correct?
That's right. it could be a small scrap of foam. Or if you are actually cutting a part, check the V and A after the cut is over. That will be sure to be your preferred setting since you will have adjusted it..
vtdiy is offline Find More Posts by vtdiy
Reply With Quote