Thread: Discussion H-bridge motor controller
View Single Post
Old Mar 30, 2012, 01:41 PM
CombatWombat is offline
Find More Posts by CombatWombat
Registered User
United States, NJ, Edison
Joined Mar 2008
34 Posts
Quote:
Originally Posted by 7500rpm View Post
He is building a brushed speed control, I always build a a separate supply voltage to run the high side this way you have only one FET in the bridge being PWM and the high side turned on hard, more efficient, and less heat from transitioning. Novak reversing controllers were this way and so were Tekin units too.
Is there a name for this separate high-side voltage supply? Charge pump relies on being intermittent, so the high-sides can't be turned on 100% duty cycle.
CombatWombat is offline Find More Posts by CombatWombat
Reply With Quote