Thread: Discussion 3DHS Fanatics!
View Single Post
Old Mar 27, 2012, 10:42 AM
Ace4 is offline
Find More Posts by Ace4
Stick banger
Ace4's Avatar
USA, AZ, Chandler
Joined Oct 2004
1,031 Posts
Quote:
Originally Posted by brathanke View Post
I need a recommendation for a throttle servo that can run on 2s unregulated. Or... I need to drop the voltage on my throttle servo. Any suggestions on what to do? I have lots of small or standard servos kicking around but nothing that will handle the voltage I'm going to run to the rx.
I bounced around on that question for awhile for my 87 SHP and just went with a Hitec 7954. It's stupid overkill, but I wanted something reasonably fast and all of the cheaper HV servos were too slow. Also in a pinch I could swap it out for one of my 7955's since the specs are the same, just not titanium gears.

I would be really hesitant about using a bunch of diodes to drop the voltage down for a regular servo. They're usually about a 0.7V drop under load (less with no-load), so you would probably need 3 of them to get a fully charged 2s LiPo below 6V. You can get a fairly inexpensive and small inline voltage regulator since it would only be operating a single servo.
Ace4 is offline Find More Posts by Ace4
Reply With Quote