View Single Post
Old Mar 23, 2012, 01:52 PM
3D-Novice is offline
Find More Posts by 3D-Novice
Registered User
Israel
Joined May 2006
262 Posts
wing continued....

OK so i found some carbon tow that i wanted to strenthen the wing , and decided to continue with the build today ..

using epoxy resin , spread the 0.6 oz cloth over the wing and dabbed using a paint brush ( not brushing but dabbing the cloth ) until the closth was saturated just enough with epoxy
then added some carbon tow , and finally sheeted wing and using as much weight as i could find and a straigh plate , pressed all together after lining them all up

i decided to only do 1 side of the wing , as time was limited

we will see tomorrow night how it comes out
3D-Novice is offline Find More Posts by 3D-Novice
Reply With Quote