View Single Post
Old Mar 18, 2012, 04:07 AM
Papiti is offline
Find More Posts by Papiti
Registered User
Belgium, Walloon Region, Beauvechain
Joined Mar 2012
100 Posts
Quote:
Originally Posted by timecop View Post
You're reading it wrong.
But after all, it's just i2c bus so you can connect many things to it at once. You can solder BMP085 breakout to BMP pads, and compass breakout to the C/D/GND pads on the bottom of the board.
I am a real newbie, so sorry if I ask a lot of explanation.
Soldering BMP085 to FF is OK (in theory )
If I add HMC5883L breakout, I read I should connect it in this way: SCL (C), SDA (D), GND, and 3V pads. But where is the 3V pad?
Papiti is offline Find More Posts by Papiti
Reply With Quote